Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGMANUAL STEERINGPOWER STEERING SYSTEMREMOVAL AND INSTALLATIONPOWER STEERING FLUID COOLERREMOVAL AND INSTALLATION
2005 Ford Taurus SEL, 4D Sedan
Removal and Installation
2005 Ford Taurus SEL, 4D SedanSECTION Removal and Installation
- Raise the vehicle on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the screws, the air deflector and the shield.
- Loosen the clamps and disconnect the hoses.
- Loosen the clamps and disconnect the hose.
- Remove the bolts, the nut, and the fluid cooler (3D746).
- To install, reverse the removal procedure.
- Fill and purge the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.