Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Tests: Notes
Do not carry out any of the following pinpoint tests unless instructed to do so. It is assumed that a fault has been detected in the system that directs entry to a specific diagnostic routine. Carrying out any pinpoint test without direction to do so can result in inaccurate diagnosis and possible replacement of functioning components. Correct test results are dependent on the correct operation of related components/systems.
Do not install any new parts unless the results indicate that they should be renewed.
When more than one diagnostic trouble code (DTC) is received, always start with the first DTC received.
For correct pinpoint test procedures, follow the steps in order as listed. Follow each step until a fault is found.
After completing any repair to the anti-lock brake system, verify that all components are correctly reconnected, clear all DTCs, turn the ignition switch from OFF to RUN, drive vehicle and perform the self-test.
The diagnostic tool can be used to take voltage and resistance measurements. Necessary probes and adapters are included in the diagnostic tool kit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.