Control Module: Service and Repair

2005 Ford Ranger 4WD V6-4.0L VIN ESECTION Service and Repair
Four-Wheel Drive (4WD) Control Module

Removal and Installation





1. Remove the audio unit.
^ Insert the removal tool.
^ Remove and support the audio unit.





2. Disconnect the audio unit electrical connector and antenna cable.





3. Remove the screws. Disengage the spring clips.
Remove the instrument panel finish panel.





4. Remove the 4WD control module.
^ Disengage the locking tangs and remove the harness connectors.
^ Remove the screws.
^ Remove the 4WD control module.
5. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.