Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005GTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1648 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS - DTC P0600 THROUGH DTC P164A - (EXCEPT DIESEL & HYBRID))DTC P06B8: INTERNAL CONTROL MODULE NON-VOLATILE RANDOM ACCESS MEMORY (NVRAM) ERROR
2005 Ford GT
DTC P06B8: Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error
2005 Ford GTSECTION DTC P06B8: Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P06B8 - INTERNAL CONTROL MODULE NON-VOLATILE RANDOM ACCESS MEMORY (NVRAM) ERROR
| Description: | This DTC indicates a concern with the ability of the powertrain control module (PCM) to correctly store permanent DTCs. | ||
| Possible Causes: | |||
| Diagnostic Aids: | Check for other DTCs and diagnose those first. Check for aftermarket performance products. If an updated calibration is available, update the calibration to the latest level. Clear the DTCs and drive the vehicle. If an updated calibration is not available, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , PROGRAMMING THE VID BLOCK FOR A REPLACEMENT PCM . |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC in table. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.