Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005GTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTION (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0454: FUEL TANK PRESSURE (FTP) SENSOR CIRCUIT NOISY
2005 Ford GT
DTC P0454: Fuel Tank Pressure (FTP) Sensor Circuit Noisy
2005 Ford GTSECTION DTC P0454: Fuel Tank Pressure (FTP) Sensor Circuit Noisy
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0454 - FUEL TANK PRESSURE (FTP) SENSOR CIRCUIT NOISY
| Description: | The fuel tank pressure changes greater than 14 inches of water in 0.10 seconds. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the FTP PID and note if it changes from above 15 inches of water to below minus (-) 15 inches of water often in 1 minute. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | - | - | GO to hD: Misfire Detection Monitor STEP HD1. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.