Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component testing procedure
2005 Ford GTSECTION Component testing procedure
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
MASTER WINDOW ADJUST SWITCH - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Power and Ground Checks before any other tests | 2 (504b) and 8 (C504a) | All eight window switches (at rest) | Open circuit |
| 2 (504b) and 4 (C504a) | |||
| 2 (504b) and 1 (C504a) | |||
| 2 (504b) and 6 (C504a) | |||
| 2 (504b) and 8 (C504b) | |||
| 2 (504b) and 3 (C504b) | |||
| 2 (504b) and 5 (C504b) | |||
| 7 (504a) and 8 (C504a) | All eight window switches (at rest) | Closed circuit | |
| 7 (504a) and 4 (C504a) | |||
| 7 (504a) and 1 (C504a) | |||
| 7 (504a) and 6 (C504a) | |||
| 7 (504a) and 8 (C504b) | |||
| 7 (504a) and 3 (C504b) | |||
| Left front window circuit | 2 (504b) and 5 (C504b) | Up | Closed circuit |
| Right front window circuit | 2 (504b) and 3 (C504b) | Down | Closed circuit |
| 7 (504a) and 8 (C504b) | |||
| 2 (504b) and 8 (C504b) | Up | ||
| 7 (504a) and 3 (C504b) | |||
| Left rear window circuit | 2 (504b) and 1 (C504a) | Down | Closed circuit |
| 7 (504a) and 6 (C504a) | |||
| 2 (504b) and 6 (C504a) | Up | ||
| 7 (504a) and 1 (C504a) | |||
| Right rear window circuit | 2 (504b) and 4 (C504a) | Down | Closed circuit |
| 7 (504a) and 8 (C504a) | |||
| 2 (504b) and 8 (C504a) | Up | ||
| 7 (504a) and 4 (C504a) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.