Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005E 150 V10-6.8L VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSERVICE AND REPAIR
2005 Ford E 150 V10-6.8L VIN S
Air Flow Meter/Sensor: Service and Repair
2005 Ford E 150 V10-6.8L VIN SSECTION Service and Repair
MASS AIR FLOW (MAF) SENSOR
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. CAUTION: Do not tamper with the mass air flow (MAF) sensing elements located in the air flow meter. Tampering can result in unit failure.
Open the air cleaner.
- Release the air cleaner clamp.
- Separate the inlet side from the outlet side of the air cleaner.
4. Release the latches and remove the MAF assembly.
5. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the MAF sensor electrical connector.
6. Remove the screws and MAF sensor.
7. CAUTION: The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will result in unmetered air entering the engine.
NOTE: Use the alignment notch to correctly align the inlet side and the outlet side of the engine air cleaner.
To install, reverse the removal procedure.
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. CAUTION: Do not tamper with the mass air flow (MAF) sensing elements located in the air flow meter. Tampering can result in unit failure.
Open the air cleaner.
- Release the air cleaner clamp.
- Separate the inlet side from the outlet side of the air cleaner.
4. Release the latches and remove the MAF assembly.
5. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the MAF sensor electrical connector.
6. Remove the screws and MAF sensor.
7. CAUTION: The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will result in unmetered air entering the engine.
NOTE: Use the alignment notch to correctly align the inlet side and the outlet side of the engine air cleaner.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.