Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005E 150 V10-6.8L VIN SREPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPSERVICE AND REPAIRLOW SERIES
2005 Ford E 150 V10-6.8L VIN S
Low Series
2005 Ford E 150 V10-6.8L VIN SSECTION Low Series
LAMP ASSEMBLY - HEADLAMP, LOW SERIES
Removal
NOTE: RH shown; LH similar.
1. NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.
Remove the headlamp door screws and remove the headlamp door.
2. Remove the screws and remove the retaining ring.
3. Disconnect the electrical connector and remove the headlamp.
Installation
1. To install, reverse the removal procedure.
- If necessary, adjust the headlamps.
Removal
NOTE: RH shown; LH similar.
1. NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.
Remove the headlamp door screws and remove the headlamp door.
2. Remove the screws and remove the retaining ring.
3. Disconnect the electrical connector and remove the headlamp.
Installation
1. To install, reverse the removal procedure.
- If necessary, adjust the headlamps.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.