Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CUTAWAY 5.4 L, 5R110WREPAIR AND DIAGNOSISENGINE MECHANICALCOOLING SYSTEM (MECHANICAL)ENGINE COOLINGSPECIFICATIONSGENERAL SPECIFICATIONS
2005 Ford Cutaway 5.4 L, 5R110W
General Specifications
2005 Ford Cutaway 5.4 L, 5R110WSECTION General Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Cooling System Capacity | |
| 4.6L | 22.6L (23.8 quarts) |
| 4.6L with aux rear heat | 24.6L (26.0 quarts) |
| 5.4L | 26.3L (27.8 quarts) |
| 5.4L with aux rear heat | 28.3L (29.8 quarts) |
| 6.8L | 27.9L (29.4 quarts) |
| 6.8L with aux rear heat | 29.9L (31.6 quarts) |
| 6.0L | 21.0L (22.2 quarts) |
| 6.0L with aux rear heat | 23.6L (24.9 quarts) |
| Coolant Type | |
| Motorcraft Premium Gold Engine Coolant VC-7-A (in California and Oregon VC-7-B, in Canada VC-7-C) | WSS-M97B51-A1 |
| Other Chemicals | |
| Premium Cooling System Flush VC-1 | ESR-M14P7-A |
| Cooling System Stop Leak Pellets VC-6 | WSS-M99B37-B6 |
| Cooling System Pressure Test Specifications | 89-124 kPa (13-18 psi) held for two minutes without pressure drop |
| Radiator Cap Pressure Test Specifications | 89-124 kPa (13-18 psi) |
| Thermostat Opening Temperature - 4.6L, 5.4L | |
| Starts to open | 86.7-90.6°C (188-195°F) |
| Fully open | 100°C (212°F) |
| Thermostat Opening Temperature - 6.8L | |
| Starts to open | 83-87°C (181-190°F) |
| Fully open | 99°C (210°F) |
| Thermostat Opening Temperature - 6.0L | |
| Starts to open | 87-91°C (189-196°F) |
| Fully open | 104°C (219°F) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.