Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CROWN VICTORIA SPECIAL EDITIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 796 (CLIMATE CONTROL - F250-F550)DESCRIPTION AND OPERATIONCONTROL COMPONENTSMANUAL CLIMATE CONTROL SYSTEM INPUTSCLIMATE CONTROL ASSEMBLY
2005 Ford Crown Victoria Special Edition
Climate Control Assembly
2005 Ford Crown Victoria Special EditionSECTION Climate Control Assembly
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
The climate control assembly has 3 system controls:
- The function selector switch combines a vacuum selector valve with 2 electrical switches to supply battery positive voltage (B+) to the blower motor control circuit and the A/C clutch circuit (if equipped).
- The temperature selection is accomplished with a potentiometer connected to the electric blend door actuator that controls positioning of the temperature blend door. Movement of the control knob from COOL (blue) to WARM (red) causes a corresponding movement on the air temperature control door and determines the temperature that the system will maintain.
- The blower motor switch controls blower motor speed by adding or bypassing resistors in the blower motor resistor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.