Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CROWN VICTORIA SPECIAL EDITIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1020 (HVAC AUXILIARY CONTROL SYSTEM - (HYBRID))SPECIFICATIONSTORQUE SPECIFICATIONS
2005 Ford Crown Victoria Special Edition
Torque Specifications
2005 Ford Crown Victoria Special EditionSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Auxiliary airflow mode door actuator screws | 2 | - | 18 |
| Auxiliary climate control housing bolts | 7 | - | 62 |
| Auxiliary climate control fresh air inlet duct nuts | 7 | - | 62 |
| Auxiliary line dash panel bracket nut | 6 | - | 53 |
| Auxiliary line floorpan bracket nuts | 6 | - | 53 |
| Battery airflow duct screws | 2 | - | 18 |
| Battery zone valve screws | 2 | - | 18 |
| Battery zone valve tube-O fitting nuts | 17 | 13 | - |
| Front auxiliary evaporator inlet line front fitting nut | 8 | - | 71 |
| Front auxiliary evaporator outlet and inlet line bracket bolt | 6 | - | 53 |
| Front auxiliary evaporator outlet and inlet line mid-joint fitting nuts | 8 | - | 71 |
| Front auxiliary evaporator outlet line front fitting nut | 15 | 11 | - |
| Rear auxiliary evaporator inlet line tube-O fitting | 10 | - | 89 |
| Rear auxiliary evaporator outlet and inlet line front bracket bolt | 6 | - | 53 |
| Rear auxiliary evaporator outlet and inlet line rear bracket bolt | 6 | - | 53 |
| Rear auxiliary evaporator outlet and inlet line rear fitting nuts | 8 | - | 71 |
| Rear auxiliary evaporator outlet line tube-O fitting | 37 | 27 | - |
| Thermostatic expansion valve (TXV) stud | 11 | 8 | - |
| TXV-to-lower bracket nut | 11 | 8 | - |
| TXV-to-upper bracket bolts | 8 | - | 71 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.