Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CROWN VICTORIA POLICE INTERCEPTOR, 4.6 WLABOR TIMESOTHER VARIANTTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVE, INSTALL, AND OVERHAUL
2005 Ford Crown Victoria Police Interceptor, 4.6 W
Transmission Assembly: Remove, Install, and Overhaul
2005 Ford Crown Victoria Police Interceptor, 4.6 WSECTION Remove, Install, and Overhaul
WARNING: This page is about the Crown Victoria Base, 4.6 9, which is a different variant/trim than selected.
TRANS ID - AOD, AOD-E, AODE-W, AOT, 4R70W, 4R75E
Includes: Inspect and replace all necessary components, clean and check Converter, flush Oil Cooler Lines, adjust and road test.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 10.6 | A |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.