Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004PICKUP F350 SUPER DUTY, 4D PICKUP, 6.8 S, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTACCESSORIES CONTROL SYSTEMSREMOTE CONVENIENCE SYSTEM -- EXCURSION & F250-F550 SUPER DUTYGENERAL PROCEDURESUNIVERSAL TRANSMITTER PROGRAMMINGNOTES
2004 Ford Pickup F350 Super Duty, 4D Pickup, 6.8 S, RWD, Automatic
Universal Transmitter Programming: Notes
2004 Ford Pickup F350 Super Duty, 4D Pickup, 6.8 S, RWD, AutomaticSECTION Notes
WARNING:
A garage door opening system that cannot stop or reverse itself after detecting an object in its path does not meet current federal safety standards. To decrease the risk of serious injury or death, do not use this HomeLink(R) universal transmitter with a door opening system that lacks stop and reverse features as required by federal standards. This includes any garage door opening system manufactured before April 1, 1982.
- Verify the hand-held transmitter is operative.
- Prepare for programming the universal transmitter by erasing all three channels (hold down the two outside buttons until the red light begins to flash [20-30 seconds]). Release both buttons.
- Select one of the three universal transmitter channels to be programmed by pressing the desired button.
- Hold the end of the hand-held transmitter 25-51 mm (1-2 inches) from the front surface of the universal transmitter so that the red light can still be seen.
CAUTION:
During this procedure, the opening system being programmed will be made to operate. Make sure that people or objects are clear of the garage door or gate being programmed.
NOTE:
For Canadian vehicles only: during programming, the hand-held transmitter may automatically stop transmitting after two seconds, which may not be long enough to program the universal transmitter. If programming this type of hand-held transmitter, continue to hold the button on the universal transmitter while re-pressing the hand-held transmitter button every two seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.