Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004MUSTANG BASE, 2D COUPE, 3.9 6, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 105 (MODULE COMMUNICATIONS NETWORK)REMOVAL & INSTALLATIONTONNEAU COVER MODULE
2004 Ford Mustang Base, 2D Coupe, 3.9 6, Automatic
Tonneau Cover Module
2004 Ford Mustang Base, 2D Coupe, 3.9 6, AutomaticSECTION Tonneau Cover Module
WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
Open power tonneau cover fully. Remove pickup bed trim panels. Remove 2 module retaining nuts. Disconnect tonneau cover module electrical connectors and remove the tonneau cover module. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.