Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004FOCUS ZX5, 2.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSSEAT BELTSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM - AIR BAG DEACTIVATION PROCEDURESDRIVER AIR BAG MODULEREMOVAL & INSTALLATION (FOCUS)
2004 Ford Focus ZX5, 2.3 Z, Standard
Removal & Installation (Focus)
2004 Ford Focus ZX5, 2.3 Z, StandardSECTION Removal & Installation (Focus)
NOTE:
Numbers in parenthesis refer to numbers shown in illustration.
- Before proceeding, see SERVICE PRECAUTIONS . Record radio preset frequencies for reprogramming (if equipped). Disconnect negative battery cable. Wait at least one minute to deplete backup power supply energy.
- Turn the steering wheel to access the air bag module captive bolts. To detach the driver air bag module from the steering wheel, undo the captive bolts (1). See Fig 1. Detach the driver air bag module retaining clips (2). Disconnect the driver air bag module electrical connector. See Fig 2. Remove the driver air bag module.
- To install, reverse removal procedure. Tighten air bag module bolts to specification. See TORQUE SPECIFICATIONS . Connect negative battery cable. Ensure system is functioning properly. See SYSTEM OPERATION CHECK . Reprogram radio preset frequencies and set clock.
CAUTION:
To prevent damage to the driver air bag module, wiring harness or steering wheel do not insert any tool between the driver air bag module and the steering wheel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.