Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004FOCUS ZX3, 2.3 Z, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST DX: ENGINE COOLANT TEMPERATURE (ECT) SENSOR THROUGH PINPOINT TEST HC: FUEL DELIVERY SYSTEM - CNG, FLEX-FUEL & GASOLINEPINPOINT TEST HA: NATURAL GAS FUEL CONTROLINTRODUCTIONNOTES
2004 Ford Focus ZX3, 2.3 Z, Standard
Pinpoint Test HA: Natural Gas Fuel Control: Introduction: Notes
2004 Ford Focus ZX3, 2.3 Z, StandardSECTION Notes
NOTE:
This pinpoint test is intended to diagnose the following:
- HO2S/HTR (Heater) (9F472).
- HO2S Connections.
- Vacuum Systems.
- Fuel Injectors.
- Harness circuits: HO2S GND, HO2S, INJ-1-8, VPWR and SIG RTN.
- Powertrain control module (PCM) (12A650).
- Natural Gas Module (NG) (9F954).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.