Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004FOCUS ZX3, 2.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGSTEERING SYSTEM-GENERAL INFORMATIONSPECIFICATIONSTORQUE SPECIFICATIONS
2004 Ford Focus ZX3, 2.3 Z, Standard
Torque Specifications
2004 Ford Focus ZX3, 2.3 Z, StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Power steering pressure switch | 20 | 15 | - |
| Pressure line to pump union | 65 | 48 | - |
| Power steering pump bolts | 23 | 17 | - |
| Pressure line support bracket (Zetec-E engine) | 25 | 18 | - |
| Pressure line support bracket (SPI engine) | 5 | - | 44 |
| Power steering gear hose clamps | 23 | 17 | - |
| Fluid cooler bolts | 5 | - | 44 |
| Steering gear bolts | 80 | 59 | - |
| Steering column shaft to steering gear pinion bolt | 35 | 26 | - |
| Crossmember rear bolts | 200 | 148 | - |
| Crossmember front bolts | 115 | 85 | - |
| Steering gear heat shield | 6 | - | 53 |
| Support insulator center bolt | 50 | 37 | - |
| Stabilizer bar link nuts | 50 | 37 | - |
| Tie-rod end retaining nuts | 47 | 35 | - |
| Wheel nuts | 128 | 94 | - |
| Steering column shaft coupling | 28 | 18 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.