Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004EXPLORER 2WD V6-4.0L VIN EREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2004 Ford Explorer 2WD V6-4.0L VIN E
Ignition Switch: Service and Repair
2004 Ford Explorer 2WD V6-4.0L VIN ESECTION Service and Repair
Steering Column Switches
CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.
1. Depower the Supplemental Restraint System (SRS).
2. Remove the parts in the order indicated in the illustration and table.
3. To install, reverse the removal procedure.
Item 6: Steering Column Upper Shroud Removal Note
1. Remove the upper steering column shroud.
1 Release the retaining clips and rotate the upper steering column trim panel out of the instrument panel.
2 Remove the upper steering column shroud hard shell.
Item 8: Ignition Switch Removal Note
1. Release the two locking tabs and remove the switch.
Item 10: Multifunction Switch Removal Note
1. Remove the screw, push the release tab and raise the switch.
Item 6: Steering Column Upper Shroud Installation Note
1. Make sure that the upper shroud retainer clips and the upper-to-lower shroud screws secure tightly or a new upper shroud must be installed.
CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.
1. Depower the Supplemental Restraint System (SRS).
Steering Column Switches:
2. Remove the parts in the order indicated in the illustration and table.
3. To install, reverse the removal procedure.
Item 6: Steering Column Upper Shroud Removal Note
1. Remove the upper steering column shroud.
1 Release the retaining clips and rotate the upper steering column trim panel out of the instrument panel.
2 Remove the upper steering column shroud hard shell.
Item 8: Ignition Switch Removal Note
1. Release the two locking tabs and remove the switch.
Item 10: Multifunction Switch Removal Note
1. Remove the screw, push the release tab and raise the switch.
Item 6: Steering Column Upper Shroud Installation Note
1. Make sure that the upper shroud retainer clips and the upper-to-lower shroud screws secure tightly or a new upper shroud must be installed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.