Recall 07V156000: ABS Module Connector Defect

2004 Ford Escape 2WD V6-3.0L VIN 1SECTION Recall 07V156000: ABS Module Connector Defect
MAKE/MODELS: MODEL/BUILD YEARS:

Ford/Escape 2001-2004

MANUFACTURER: Ford Motor Company

NHTSA CAMPAIGN ID NUMBER: 07V156000 MFR'S REPORT DATE: March 30, 2007

COMPONENT: Service Brakes, Hydraulic: Antilock: Control Unit/Module

POTENTIAL NUMBER OF UNITS AFFECTED: 446460

SUMMARY:
On certain sport utility vehicles equipped with Antilock Brakes (ABS), the ABS module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.

CONSEQUENCE:
An electrical short might cause an ABS malfunction that would illuminate the ABS warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire. This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.

Remedy:
Dealers will inspect the wire harness connector to the ABS module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate. The dealer will also inspect the connector on the ABS module and replace it if it is found to be corroded or damaged. The recall began on April 23, 2007. Owners may contact Ford at 1-800-392-3673.

NOTES:
Ford recall No. 07S51. Customers may also contact The National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to http://www.safercar.gov.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.