Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ESCAPE 2WD V6-3.0L VIN 1REPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFSERVICE AND REPAIRROOF OPENING PANEL SHIELD
2004 Ford Escape 2WD V6-3.0L VIN 1
Roof Opening Panel Shield
2004 Ford Escape 2WD V6-3.0L VIN 1SECTION Roof Opening Panel Shield
ROOF OPENING PANEL SHIELD
REMOVAL
1. Remove the roof opening panel.
2. Remove the water channel.
1 Remove the bolts.
2 Remove the water channel.
3. Slide the roof opening panel shield forward.
4. Remove the roof opening panel shield.
1 Disengage the four spring loaded guides.
2 Remove the roof opening panel shield.
INSTALLATION
1. To install, reverse the removal procedure.
REMOVAL
1. Remove the roof opening panel.
2. Remove the water channel.
1 Remove the bolts.
2 Remove the water channel.
3. Slide the roof opening panel shield forward.
4. Remove the roof opening panel shield.
1 Disengage the four spring loaded guides.
2 Remove the roof opening panel shield.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.