Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ESCAPE 2WD V6-3.0L VIN 1REPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFSERVICE AND REPAIRROOF OPENING PANEL
2004 Ford Escape 2WD V6-3.0L VIN 1
Roof Opening Panel
2004 Ford Escape 2WD V6-3.0L VIN 1SECTION Roof Opening Panel
ROOF OPENING PANEL
REMOVAL
1. Open the roof opening panel to the vent position.
2. Remove the four roof opening panel bolts.
3. From outside the vehicle, remove the roof opening panel.
INSTALLATION
1. To install, reverse the removal procedure.
- Check for correct alignment of the roof opening panel.
REMOVAL
1. Open the roof opening panel to the vent position.
2. Remove the four roof opening panel bolts.
3. From outside the vehicle, remove the roof opening panel.
INSTALLATION
1. To install, reverse the removal procedure.
- Check for correct alignment of the roof opening panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.