Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2004ESCAPE 2.0 BREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE SYSTEM-GENERAL INFORMATIONGENERAL PROCEDURESPUSH ROD CLEANING AND INSPECTION

2004 Ford Escape 2.0 B

Push Rod Cleaning And Inspection

2004 Ford Escape 2.0 BSECTION Push Rod Cleaning And Inspection

Fig 1: Identifying Special Tool(s)

Courtesy of FORD MOTOR CO.

Clean the push rods (6565) in a suitable solvent. Blow out the oil passage in the push rods with compressed air.

CAUTION: Do not attempt to straighten push rods.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.