Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 961 (IDENTIFICATION CODES)DESCRIPTION AND OPERATIONIDENTIFICATION CODESVEHICLE CERTIFICATION (VC) LABEL REFERENCEAXLE RATIO CODE
2004 Ford Econoline E150, Van Cargo, 4.6 W
Axle Ratio Code
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Axle Ratio Code
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
The axle ratios are:
- 58 - 2.73 conventional (non-limited slip) - without Traction Control
- Z5 - 3.27 conventional (non-limited slip)
- C6 - 3.55 limited slip
- X5 - 3.27 limited slip
- C8 - 2.73 conventional (non-limited slip) - with Traction Control
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.