SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (ENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATION)COMPUTERIZED ENGINE CONTROLSPOWERTRAIN CONTROL MODULEREMOVAL & INSTALLATION
2004 Ford Econoline E150, Van Cargo, 4.6 W

Removal & Installation

2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Mercury Grand Marquis, 2002 Lincoln Town Car, and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Loosen PCM connector retaining bolt, located behind master cylinder. Unplug harness connector from PCM. Remove 2 PCM cover nuts and cover. Remove driver's side instrument panel under cover. Remove PCM. To install, reverse removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.