Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 451 (FOUR WHEEL DRIVE SYSTEMS)SPECIFICATIONSTORQUE SPECIFICATIONS CHART
2004 Ford Econoline E150, Van Cargo, 4.6 W
Torque Specifications Chart
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Torque Specifications Chart
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS CHART
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Breather barb | 8-14 | 6-10 | - |
| Transfer case bolts | 25 | 18 | - |
| Dampener nuts | 22 | 16 | - |
| Drain plug | 15 | 11 | - |
| Transfer case to transmission bolts | 41 | 30 | - |
| Fill plug | 15 | 11 | - |
| Rear output flange nut | 355 | 262 | - |
| Transfer case shift motor bolts | 10 | - | 89 |
| Clutch coil assembly nuts | 10 | - | 89 |
| Skid plate bolts | 24 | 18 | - |
| Damper snubber screws | 7 | - | 62 |
| Cross member bolts | 63 | 46 | - |
| Transmission mount bolts | 90 | 66 | - |
| Transmission mount nuts | 98 | 72 | - |
| Heat shield bolts | 15 | 11 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.