SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 343 (HVAC - CLIMATE CONTROL SYSTEM)DIAGNOSIS AND TESTINGCLIMATE CONTROL SYSTEMVACUUM APPLICATION CHART - DUAL AUTOMATIC TEMPERATURE CONTROL
2004 Ford Econoline E150, Van Cargo, 4.6 W

Vacuum Application Chart - Dual Automatic Temperature Control

2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Vacuum Application Chart - Dual Automatic Temperature Control
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
VACUUM APPLICATION CHART - DUAL AUTOMATIC TEMPERATURE CONTROL

Color Function Manual Override Buttons
OFF PANEL FLOOR/PANEL FLOOR FLOOR/DEFROST DEFROST
Black Vacuum source V V V V V V
White(1) Air inlet door V V/NV V/NV V/NV NV NV
Yellow Defrost door V V V V NV NV
Blue Floor door NV NV V V V NV
Red Panel door NV V V NV NV NV
Gray Heater control valve(2) V - - - - -
(1) The DATC system may be manually set to enable or disable the recirculation of cabin air by pressing the RECIRCULATION manual override button in all manual override modes except OFF, DEFROST, and FLOOR/DEFROST.

(2) The automatic temperature control solenoid and manifold will supply vacuum and close the heater control valve depending on the DATC module settings and ambient conditions in any setting except OFF.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.