Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 336 (ENGINE COOLING SYSTEM)
2004 Ford Econoline E150, Van Cargo, 4.6 W
Section 336 (Engine Cooling System)
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Section 336 (Engine Cooling System)
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- General Procedures
- Removal And Installation
- Block Heater
- Thermostat and Thermostat Housing - 4.0L SOHC
- Thermostat and Thermostat Housing - 4.6L (2V)
- Water Pump - 4.0L SOHC
- Water Pump - 4.6L
- Radiator, Cooling Fan And Shroud
- Notes
- Removal
- Item 9: Lower Degas Bottle Hose Removal Note
- Item 10: A/C Tube Removal Note
- Item 11: Transmission Cooler and A/C Tubes Removal Note
- Item 12: Radiator Fan Shroud Screw Removal Note
- Item 15: Cooling Fan Removal Note
- Item 17: Radiator Lower Fan Shroud Removal Note
- Item 19: Radiator Bracket Bolt Removal Note
- Item 21: A/C Condenser Support Bracket Bolt Removal Note
- Item 22: Radiator Removal Note
- Item 22: Radiator Installation Note
- Item 21: A/C Condenser Support Bracket Installation Note
- Item 19: Radiator Bracket Installation Note
- Item 17: Radiator Lower Fan Shroud Installation Note
- Item 15: Cooling Fan Installation Note
- Item 11: Transmission Cooler and A/C Tube Installation Note
- Item 10: A/C Tube Installation Note
- Item 9: Lower Degas Bottle Hose Installation Note
- Degas Bottle
- Cooling Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.