Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 302 (BRAKE SYSTEM)DIAGNOSIS AND TESTINGBRAKE SYSTEMCONNECTOR CIRCUIT REFERENCEADJUSTABLE PEDAL SWITCH C2089
2004 Ford Econoline E150, Van Cargo, 4.6 W
Adjustable Pedal Switch C2089
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Adjustable Pedal Switch C2089
WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
PIN NUMBER (S) AND CIRCUIT DESIGNATION/DESCRIPTION
| Pin Number (s) | Circuit Designation/Description | Normal Condition/Measurement |
|---|---|---|
| 2 | 1205 (BK) adjustable pedal switch ground circuit | Less than 5 ohms resistance between the adjustable pedal connector (disconnected) and ground. |
| 4 (without memory) | 1495 (WH) adjustable pedal motor power feed or ground (switched) | Greater than 10 volts with motor in one direction and ground when in opposite direction. Less than 5 ohms resistance between the adjustable pedal switch and the adjustable pedal motor connectors (both disconnected). |
| 4 (with memory) | 1495 (WH) adjustable pedal rearward signal input to the DSM (uses a voltage reference signal from the DSM to the adjustable pedal switch) | Less than 5 ohms resistance between the adjustable pedal switch and the DSM connectors (both disconnected). |
| 6 (without memory) | 1567 (RD/LB) adjustable pedal switch power feed | Greater than 10 volts between the adjustable pedal switch connector (disconnected) and ground. |
| 6 (with memory) | 1205 (BK) adjustable pedal switch ground | Less than 5 ohms resistance between the adjustable pedal switch connector (disconnected) and ground. |
| 8 (without memory) | 1494 (RD) adjustable pedal motor ground or power feed (switched) | Less than 5 ohms resistance between the adjustable pedal switch and the adjustable pedal motor connectors (both disconnected). |
| 8 (with memory) | 1494 (RD) adjustable pedal forward signal input to the DSM (uses a voltage reference signal from the DSM to the adjustable pedal switch) | Less than 5 ohms resistance between the adjustable pedal switch and the DSM connectors (both disconnected). |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.