Suspension System Alignment Specifications

2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Suspension System Alignment Specifications
WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
SUSPENSION SYSTEM ALIGNMENT SPECIFICATIONS

Item LH RH Split
Front 
Caster 3.5 ° +/- 0.75° 3.5 ° +/- 0.75° 0.0 ° +/- 0.75°
Camber -0.4 ° +/- 0.75 ° -0.4 ° +/- 0.75° 0° +/- 0.75°
Toe @ curb ride height (positive value is toe-in, negative value is toe-out) - - -0.15° +/-0.25°
Rear 
Camber -0.3 ° +/- 0.75 ° -0.3 ° +/- 0.75° -
Toe @ curb ride height (positive value is toe-in, negative value is toe-out) 0.07° +/- 0.20° 0.07° +/- 0.20° 0.14° +/- 0.20°
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.