Front Panel DATC Module Self-Test (On-Demand Diagnostic Trouble Codes - DTCs)

On-demand DTCs are those that are reported by an ECU when a failure is detected while executing a diagnostic test. For the DATC module this means that all faults (hard) that occur while the module is conducting a self-test shall be reported as an on-demand DTC.

• The DATC module self-test will not detect concerns associated with data link messages such as engine coolant temperature or vehicle speed signals. The scan tool must be used to retrieve these concerns.
• The vehicle interior temperature should be between 0-32°C (32-90°F) when carrying out the self-test. If the temperatures are not within the specified ranges, false temperature sensor DTCs may be displayed.

The DATC module self-test through the front panel display:

• Can be initiated at any time. Normal operation of the system stops when the self-test is activated.
• Is entered by pressing the OFF and DEFROST buttons simultaneously and then pressing the AUTO button within two seconds. Record all DTCs displayed.
• Concludes by reporting all on-demand DTCs. Follow the diagnostics procedure given under ACTION in the DTC index for each DTC given.
• Reports individual on-demand DTCs as four-digit DTCs (less the alpha character).
• Will calibrate all the mode doors and check all analog inputs. The DATC module will only report on-demand (hard) faults that occurred while the DATC module was conducting its self-test.
• Will light all control panel display segments if no faults are detected.
• Will report individual on-demand DTCs without the °C symbol lit.

To exit the self-test, press the defrost button. This will clear all on-demand codes from the DATC module memory. If no button is pushed, DTCs will continue to be displayed.

Upon exit from the self-test the DATC module returns to operational status. The DATC module executes a hard (cold boot) reset which places the DATC system in the OFF mode.

If a condition exists but no DTCs appear during the self-test, GO to SYMPTOM CHART  Condition: The DATC System Is Inoperative, Intermittent or Incorrect Operation.

Always exit the self-test before powering the system down (system turned OFF).