Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 250 (AUTOMATIC TRANSAXLE/TRANSMISSION)SPECIFICATIONSTORQUE SPECIFICATIONS
2004 Ford Econoline E150, Van Cargo, 4.6 W
Torque Specifications
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | N.m | lb-ft | lb-in |
|---|---|---|---|
| Accumulator support bolts | 8 | - | 71 |
| Battery ground cable | 5 | - | 44 |
| Crankshaft position sensor heat shield nut | 13 | 10 | - |
| Differential lubrication tube bolts | 6 | - | 54 |
| Engine/Transaxle brace bolts | 35 | 26 | - |
| Engine/Transaxle splash shield bolts | 9 | - | 80 |
| Engine/Transaxle splash shield screw | 9 | - | 80 |
| Engine to transaxle bolts | 44 | 32 | - |
| Final drive ring gear bolts | 120 | 89 | - |
| Front transaxle support insulator bolts | 47 | 35 | - |
| Front transaxle support insulator through bolt | 69 | 51 | - |
| Idler gear locknut | 309 | 228 | - |
| Inner fender splash shield bolts | 5 | - | 44 |
| Pressure control solenoid bolt | 8 | - | 71 |
| Low/Reverse clutch apply oil transfer tube bolts | 6 | - | 54 |
| Lug nuts | 108 | 80 | - |
| Main control valve body bolts | 8 | - | 71 |
| Manual detent spring retaining bolt | 7 | - | 62 |
| Oil cooler tube bolts | 39 | 29 | - |
| Oil cooler tube bracket bolt | 4 | - | 36 |
| Oil pump bolts | 20 | 15 | - |
| Oil pump cover bolts | 9 | - | 80 |
| Output shaft bearing retainer bolts | 22 | 16 | - |
| Output shaft speed sensor bolt | 6 | - | 54 |
| Parking actuator support bolts | 22 | 16 | - |
| Rear transaxle support insulator bolts | 49 | 36 | - |
| Rear transaxle support insulator mount nuts | 35 | 26 | - |
| Rear transaxle mount through bolt | 49 | 36 | - |
| Reduction gear bearing outer race bolts | 116 | 85 | - |
| Shifter cable nut | 9 | - | 80 |
| Torque converter bolts | 52 | 38 | - |
| Torque converter housing bolts | 45 | 34 | - |
| Transmission control module (TCM) bracket bolts | 5 | - | 44 |
| Transaxle bellhousing bolts | 35 | 26 | - |
| Transaxle drain plug | 34 | 25 | - |
| Transaxle fill tube ground strap nut | 4 | - | 36 |
| Transaxle fill tube bolt | 4 | - | 36 |
| Transaxle filter bolts | 8 | - | 71 |
| Transaxle fluid pan bolts | 8 | - | 71 |
| Transaxle range (TR) sensor screws | 3 | - | 27 |
| Transaxle side cover bolts | 28 | 21 | - |
| Valve body solenoid bolts | 8 | - | 71 |
| 2-4 servo piston retainer bolts | 22 | 16 | - |
| Vehicle speed sensor (VSS) bolt | 6 | - | 53 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.