Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2068 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)SPECIFICATIONSTORQUE SPECIFICATIONS
2004 Ford Econoline E150, Van Cargo, 4.6 W
Torque Specifications
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Torque Specifications
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| ABS module screws | 2 | - | 18 |
| Front and rear brake tube fittings | 15 | - | 133 |
| Front wheel speed sensor harness-to-body bolt | 9 | - | 80 |
| Front wheel speed sensor harness-to-strut bracket bolt | 15 | - | 133 |
| Hydraulic Control Unit (HCU) bracket-to-frame bolts | 20 | - | 177 |
| HCU bracket-to-HCU bolts | 9 | - | 80 |
| HCU heat shield bolts (Hybrid only) | 5 | - | 44 |
| Jumper tube assembly bracket nut | 9 | - | 80 |
| Jumper tube fittings | 15 | - | 133 |
| Master cylinder brake tube fittings | 23 | 17 | - |
| Rear wheel hub nut | 290 | 214 | - |
| Rear wheel speed sensor harness bolts | 9 | - | 80 |
| Wheel speed sensor bolts | 9 | - | 80 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.