Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1106 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)DIAGNOSIS AND TESTINGANTI-LOCK CONTROL - HYBRIDTRANSMISSION CONTROL MODULE (TCM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX
2004 Ford Econoline E150, Van Cargo, 4.6 W
Transmission Control Module (TCM) Diagnostic Trouble Code (DTC) Index
2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Transmission Control Module (TCM) Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TRANSMISSION CONTROL MODULE (TCM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| C1218 | Lamp ABS Warning Output Circuit Failure | TCM | Repair all other DTCs first before proceeding with this pinpoint test. GO to PINPOINT TEST K . |
| C1222 | Speed Wheel Mismatch | TCM | GO to PINPOINT TEST I . |
| C1233 | Wheel Speed LF Input Signal Missing | TCM | GO to PINPOINT TEST I . |
For a complete list of TCM DTCs, refer to INTRODUCTION - HYBRID article .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.