SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1093 (POWER STEERING SYSTEM)REMOVAL AND INSTALLATIONPOWER STEERING CONTROL (PSC) MODULEREMOVAL AND INSTALLATION
2004 Ford Econoline E150, Van Cargo, 4.6 W

Removal and Installation

2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - HYBRID .
    • Position the BJB aside.
  2. Disconnect the power steering control module electrical connectors.
  3. Remove the 2 power steering control module nuts.
    • To install, tighten to 23 Nm (17 lb-ft).
  4. Remove the power steering control module ground cable bolt.
  5. Remove the power steering control module nuts from inside the vehicle.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. Remove the power steering control module.
  7. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.