Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Control Module: Service and Repair
2004 Ford E 350 V10-6.8L VIN SSECTION Service and Repair
POWERTRAIN CONTROL MODULE (PCM)
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. Disconnect the powertrain control module (PCM) electrical connector.
4. Remove the PCM.
1 Remove the nuts.
2 Remove the cover.
3 Remove the PCM.
INSTALLATION
1. To install, reverse the removal procedure.
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. Disconnect the powertrain control module (PCM) electrical connector.
4. Remove the PCM.
1 Remove the nuts.
2 Remove the cover.
3 Remove the PCM.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.