2003 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS

Item Specification
Lubricants 
MERCON® Multi-Purpose Transmission Fluid XT-2-QDX MERCON®
Power Steering Gear 
Static steering wheel turning effort 3.7 N.m (33 lb-in)
Turns lock-to-lock 2.74
Power Steering Purge Vacuum 
Air purge vacuum 68-85 kPa (20-25 in-Hg)
Power Steering Pump 
Flow 2.4 +/- 0.2 gpm @ 145 psi & 1,500 RPM
Minimum capacity 1.0 gpm @ 725 psi @ 500 RPM
Relief pressure 1,624-1,740 psi
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.