Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Section 344 (Steering System)
WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- Steering System
- Special Tool(s)
- Material
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Connector Reference and Terminal Readings
- Front Electronic Module (FEM)-C201a
- Front Electronic Module (FEM)-C201b
- VAPS Solenoid-C120
- PINPOINT TEST A: No Communication With The FEM Module/Unable To Enter Self-Test
- PINPOINT TEST B: DTC 1924 - VAPS Solenoid Actuator Output Short To Ground
- PINPOINT TEST C: DTC 1925 - VAPS Solenoid Actuator Return Circuit Failure
- Pinpoint Tests D: Hard Steering/Lack of Assist With No DTCs
- PINPOINT TEST E: Steering System Noise
- PINPOINT TEST F: Steering is Very Difficult/Very Easy
- PINPOINT TEST G: Excessive Steering Wheel Play
- PINPOINT TEST H: Steering System Drift/Pull/Wander
- Component Tests
- Steering Column Switches
- Special Tool(s)
- Wiring Diagrams
- Inspection and Verification
- Symptom Chart
- Connector Reference and Terminal Readings
- Pinpoint Tests
- Component Test
- Steering Column
- Notes
- Special Tool(s)
- Inspection and Verification
- Symptom Chart
- Connector Circuit Reference
- Pinpoint Tests
- Steering System
- General Procedures
- Removal And Installation
- Disassembly And Assembly
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
