Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2111 (HYDRAULIC BRAKE SYSTEM ACTUATION)SPECIFICATIONSTORQUE SPECIFICATIONS TABLE
2003 Ford Windstar Base
Torque Specifications Table
2003 Ford Windstar BaseSECTION Torque Specifications Table
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS TABLE
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Brake booster nuts a | - | - | - |
| Brake fluid remote reservoir nuts | 7 | - | 62 |
| Brake fluid reservoir pin bolt | 6 | - | 53 |
| Brake master cylinder brake tube fittings (non-hybrid) | 28 | 21 | - |
| Brake master cylinder brake tube fittings (hybrid) | 20 | - | 177 |
| Brake master cylinder nuts | 20 | - | 177 |
| Brake pedal and bracket upper bolts | 23 | 17 | - |
| Brake pedal angle sensor screws | 2 | - | 18 |
| Brake pedal bracket bolts | 23 | 17 | - |
| Brake pressure control valve bolts | 11 | - | 97 |
| Brake pressure control valve brake tube fittings | 20 | - | 177 |
| Steering column opening trim panel reinforcement bolts | 3 | - | 27 |
| a Refer to the appropriate procedure(s). | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.