Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 196 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM - EXCEPT F150)SYSTEM OPERATION CHECK
2003 Ford Windstar Base
System Operation Check
2003 Ford Windstar BaseSECTION System Operation Check
WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
- When checking air bag system operation (also known as prove out system), and upon completion of each diagnostic test, check for faults in air bag system. To check system, turn ignition switch to RUN position. If AIR BAG warning light illuminates for 6 seconds and then goes out, air bag system is functioning properly and no faults exist.
- If a fault is detected in air bag system during initial system check, AIR BAG warning light will flash a code sequence, indicating a fault in system. Count number of flashes after fault code has cycled twice. Number of flashes represents a code number used to diagnose air bag system. See DIAGNOSTICS . If AIR BAG warning light either fails to light or stays on continuously, go to DIAGNOSTIC SYMPTOMS .
- If a system fault exists and AIR BAG warning light fails to light, an audible tone will be heard, indicating AIR BAG warning light is out and service is required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.