P0605 - Internal Control Module Read Only Memory (ROM) Error

2003 Ford Windstar BaseSECTION P0605 - Internal Control Module Read Only Memory (ROM) Error
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
P0605 - INTERNAL CONTROL MODULE READ ONLY MEMORY (ROM) ERROR

Description:  The powertrain control module (PCM) ROM has been corrupted.
Possible Causes: 
  • An attempt was made to change the calibration
  • Module programming error
  • Damaged PCM
Diagnostic Aids:  Reprogram or update the calibration. Reprogram the VID block (use as built data). Check for other DTCs or drive symptoms for additional information.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All   Be sure to check for aftermarket performance products before replacing the PCM. If replacement is necessary, refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.