Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1537 (ANTI-THEFT - PERIMETER)
2003 Ford Windstar Base
Section 1537 (Anti-Theft - Perimeter)
2003 Ford Windstar BaseSECTION Section 1537 (Anti-Theft - Perimeter)
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Anti-Theft - Perimeter
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The Alarm System Does Not Disarm - From The Driver Door
- Pinpoint Test B: The Alarm System Does Not Arm/Disarm - Using The Remote Keyless Entry (RKE) Transmitter
- Pinpoint Test C: The Alarm System Does Not Operate Correctly - Alarm Does Not Activate With Hood Ajar/Open
- Pinpoint Test D: The Alarm System Does Not Operate Correctly - Flashers Or Horn Do Not Cycle During Anti-Theft Activation
- Pinpoint Test E: The Alarm System Does Not Operate Correctly - The Alarm Does Not Inhibit From The Luggage Compartment Anti-Theft Inhibit Switch
- Anti-Theft - Perimeter
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.