Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Mounts: Installation
2003 Ford Windstar BaseSECTION Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Position the RH engine mount and install the 4 bolts.
- Tighten to 63 Nm (46 lb-ft).
- Position the LH engine mount and install the 4 bolts.
- Tighten to 63 Nm (46 lb-ft).
- Lower the engine into position.
RH engine mount
CAUTION:
Clean the engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
LH engine mount
CAUTION:
Clean the engine mount-to-oil filter adapter and engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
All vehicles
CAUTION:
Only use hand tools when installing the RH engine mount nut or damage to the engine mount can occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.