Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGPOWER STEERING SYSTEMREMOVAL AND INSTALLATIONPUMP-CIIREMOVAL

2003 Ford Windstar Base

Removal And Installation: Pump-CII: Removal

2003 Ford Windstar BaseSECTION Removal

Remove the drive belt. For additional information, refer to ACCESSORY DRIVE .
Disconnect the power steering reservoir pump hose (3E525).

Fig 1: Disconnecting Power Steering Reservoir Pump Hose
Courtesy of FORD MOTOR CO.
Disconnect the power steering hose (3A719). Remove and discard the seal.

Fig 2: Disconnecting Power Steering Hose
Courtesy of FORD MOTOR CO.
Remove the four bolts, two brackets and power steering pump (3A674).

Fig 3: Removing Four Bolts
Courtesy of FORD MOTOR CO.
Remove the power steering pump pulley. For additional information, refer to PULLEY - CIII PUMP .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.