Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Activating System (Escape)
2003 Ford Windstar BaseSECTION Activating System (Escape)
- Disconnect negative battery cable. Wait at least one minute for backup power supply to deplete stored energy. Remove air bag simulator from clockspring connector. Reconnect air bag module connector. Install steering wheel access panel.
- Remove air bag simulator from passenger air bag vehicle harness connector. Reconnect air bag module connector. Restore glove box to original position.
- Disconnect side air bag simulators. Reconnect side air bag module connectors. Disconnect seat belt pretensioner simulators. Reconnect seat belt pretensioner connectors. Reconnect negative battery cable. Recheck system operation. Perform SYSTEM OPERATION CHECK . Reprogram preset radio frequencies and set clock.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.