Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSDIAGNOSTIC CONNECTOR (DLC) LOCATIONSIMPORTED CARS & TRUCKSNISSAN
2003 Ford Windstar Base
Imported Cars & Trucks: NISSAN
2003 Ford Windstar BaseSECTION NISSAN
NOTE:
This table provides a quick reference for self-diagnostic connector locations, when available from manufacturer, that ARE NOT
located at the lower left side of the dash, as mandated in 1996 by the Federal government.
NISSAN - IMPORTED CARS & TRUCKS
| Application | Connector Location | ||
|---|---|---|---|
| Altima | |||
| 1993-94 | On Driver-Side Of Center Console, Above Accelerator Pedal | ||
| 1995-96 | Below Fuse Box | ||
| Maxima | |||
| 1989-94 | Under Left Side Of Dash | ||
| 1995-96 | Below Fuse Box | ||
| NX & Sentra | Under Left Side Of Dash, Near Fuse Block | ||
| Pulsar NX | |||
| 1986 | Above Right Side Of Dash, Below Wiper Motor | ||
| 1987 | Above Steering Column | ||
| Quest (1993-95) | |||
| CONSULT Tester Connector | On Driver-Side Of Center Console, Above Accelerator Pedal | ||
| Self-Test Connector | Located Near Starter | ||
| Stanza | Below Center Of Dash, Near Center Console | ||
| Van | On Right Side Of Engine Compartment, Behind Fuel Filter | ||
| 200SX (1995-96) | Below Fuse Box | ||
| 240SX | |||
| 1991-94 | Under Left Side Of Dash, Below Fuse Block | ||
| 1995-96 | In Glove Box | ||
| 300ZX (1990) | Near Parking Brake | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.