Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2003WINDSTAR BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE SYSTEM-GENERAL INFORMATIONGENERAL PROCEDURESHYDRAULIC LEAK CHECK
2003 Ford Windstar Base
Hydraulic Leak Check
2003 Ford Windstar BaseSECTION Hydraulic Leak Check
- Make sure the brake master cylinder reservoir (2K478) is full.
- Apply the brakes several times and make sure the brake pedal (2455) feel is not spongy. If necessary, bleed the system. Refer to BLEEDING - SYSTEM .
- Hold pressure on the brake pedal for 30 seconds.
- Verify that the reservoir level is dropping.
- If the reservoir level is dropping, inspect the brake components, fittings and lines to locate the source of the leak.
NOTE:
Brake fluid is water soluble and it is possible that all evidence of fluid leakage has been washed off if the vehicle has been operated in the rain or snow.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.