2002 Ford Excursion 2WD V10-6.8LFACTORY OEM SERVICE PROCEDURE

Starter Relay: Service and Repair

REMOVAL

WARNING: WHEN CARRYING OUT MAINTENANCE ON THE STARTING SYSTEM BE AWARE THAT HEAVY GAUGE LEADS ARE CONNECTED DIRECTLY TO THE BATTERY. MAKE SURE PROTECTIVE CAPS ARE IN PLACE WHEN MAINTENANCE IS COMPLETE.

1. Disconnect the battery ground cable.


Factory service manual diagram





2. Remove the relay cover.


Factory service manual diagram





3. Disconnect the starter motor solenoid relay switch wires and cables.
1 Disconnect the engine control sensor wiring.
2 Remove the nuts.
3 Remove the cables.


Factory service manual diagram





4. Remove the starter motor solenoid relay switch.
1 Remove the bolts.
2 Remove the starter motor solenoid relay switch.

INSTALLATION

1. WARNING: WHEN CARRYING OUT MAINTENANCE ON THE STARTING SYSTEM BE AWARE THAT HEAVY GAUGE LEADS ARE CONNECTED DIRECTLY TO THE BATTERY. MAKE SURE PROTECTIVE CAPS ARE IN PLACE WHEN MAINTENANCE IS COMPLETE.


Factory service manual diagram





2. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.