Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Excursion 2WD V10-6.8LFACTORY OEM SERVICE PROCEDURE
Alternator: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Relieve the accessory drive belt tension and remove the belt from the generator pulley. Leave the belt in place for reinstallation.

3. Disconnect the generator wiring harness.
^ Remove the nut and disconnect the B+ cable.
^ Disconnect the electrical connector.
^ Release the harness locator.

4. Remove the generator bracket.
^ Remove the bolts and stud.

5. Remove the generator.
^ Loosen the lower generator bolts.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Be sure to hand-start the generator battery positive cable nut to prevent cross-threading.
1. Disconnect the battery ground cable.
2. Relieve the accessory drive belt tension and remove the belt from the generator pulley. Leave the belt in place for reinstallation.
3. Disconnect the generator wiring harness.
^ Remove the nut and disconnect the B+ cable.
^ Disconnect the electrical connector.
^ Release the harness locator.
4. Remove the generator bracket.
^ Remove the bolts and stud.
5. Remove the generator.
^ Loosen the lower generator bolts.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Be sure to hand-start the generator battery positive cable nut to prevent cross-threading.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
