Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Excursion 2WD V10-6.8LFACTORY OEM SERVICE PROCEDURE
Ignition System: Description and Operation
Component Locations:
The 5.4L and 6.8L engines are equipped with a coil on plug ignition system. This system has a separate ignition coil mounted on each spark plug. Operation of the coils is controlled by the Powertrain Control Module (PCM), which computes ignition timing based on inputs from the electronic engine control system sensors.
The ignition coils change the low voltage signal from the powertrain control module into high voltage pulses to the spark plugs.
The ignition system is set for base timing at 10 degrees Before Top Dead Center (BTDC) and is not adjustable.
Refer to Specifications for firing order.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
