Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Excursion 2WD V10-6.8LFACTORY OEM SERVICE PROCEDURE
Ground Locations
G100 engine compartment, rear, LH side - Gasoline engines
G100 engine compartment, rear, LH side - Diesel engines
G101 engine compartment, LH side
G102 engine, RH side
G104 engine compartment, right fender
G105 engine compartment, front, LH side
G106 engine compartment, RH side, on frame rail
G108 engine compartment, RH side - Gasoline engines
G108 engine compartment, RH side - Diesel engines
G109 engine compartment, LH side
G111 engine, top
G200 behind dash panel, center
G201 behind dash panel, center
G202 behind dash panel, center
G203 under dash panel, RH side
G300 LH A-pillar, behind trim panel
G301 Vehicle interior, LH side, after C-pillar
G400 vehicle underbody, rear, chassis side member, LH side
G403 RH D-pillar
G900 LH C-pillar
G901 vehicle rear end, roof
G100 engine compartment, rear, LH side - Diesel engines
G101 engine compartment, LH side
G102 engine, RH side
G104 engine compartment, right fender
G105 engine compartment, front, LH side
G106 engine compartment, RH side, on frame rail
G108 engine compartment, RH side - Gasoline engines
G108 engine compartment, RH side - Diesel engines
G109 engine compartment, LH side
G111 engine, top
G200 behind dash panel, center
G201 behind dash panel, center
G202 behind dash panel, center
G203 under dash panel, RH side
G300 LH A-pillar, behind trim panel
G301 Vehicle interior, LH side, after C-pillar
G400 vehicle underbody, rear, chassis side member, LH side
G403 RH D-pillar
G900 LH C-pillar
G901 vehicle rear end, roof
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.